Beli morse taper drill di monotaro.id

Dokumentasi Produk:WARRANTY MonotaRO Private Brand

Morse Taper Drive to Threaded Mount Precision machined, fully hardened and ground to give maximum surface contact.

Morse Taper Sleeve.

Absorption of the piping strain in the line of water, steam, oil, chemicals, etc., absorption of vibration and ground sinking.

Digunakan untuk menyambungan bor cones dengan ukuran berbeda

It is used to reduce Morse taper size of drill and reamer. (For matching with the taper size of the spindle of the drilling machine used)

Drill Chuck Arbor MT2 X B16 adalah alat yang digunakan pada mensin bor sebagai aksesoris utama untuk memegang mata bor. Alat ini digunakan untuk memegang mata bor saat dilakukan pengeboran sehingga dapat digunakan pada putaran tinggi tanpa perlu khawatir mata bor yang digunakan terlepas. Alat ini dikencangkan dengan secara manual dengan menggunakan pin Chuck. Drill Chuck Arbor ini mempunyai dimensi 112x16x16mm. Drill Chuck Arbor sering digunakan di industri, pabrik atau bengkel.

- Use it when you want to change the size of Morse taper or want to extend it.

It is used when using drill chuck etc in drilling machine or lathe.Dokumentasi Produk:WARRANTY MonotaRO Private Brand

-Use it to reduce morse taper size of drill and reamer. (For matching with the taper size of the spindle of the drilling machine used)

MORSE TAPER EXTENSION SOCKETSFor adapting tools with morse taper shanks to machine having smaller morse taper spindle or for adapting tools with morse taper shanks to machine having the same or larger morse taper spindle.Hardened and ground throughout.

A range of quality traditional workholding equipment. Manufactured from high quality steel and case hardened all over. All sleeves and sockets are fully hardened and ground internally and externally. ISO 238 BS 1660 : 2. Drill Sleeve & Drift Set Set of three drill sleeves 1 - 2, 2 - 3, 3 - 4 MT. Fully hardened and ground inside and out. Two drill drifts to release 1 - 2 and 3 - 4 MT.

Drill Sleeves A range of quality traditional workholding equipment. Manufactured from high quality steel and case hardened all over. All sleeves and sockets are fully hardened and ground internally and externally. ISO 238 BS 1660 : 2.

-Used in drill press and lathes, and use drill chuck etc. attached to arbor like sleeve and socket.